How to Take Apart and Put Together an Airsoft Gun

G&Chiliad Xtreme45 airsoft Disassembly

Comments: 1
Favorites: 1
Completions: 1

G&G Xtreme45 airsoft Disassembly

Introduction

This guide volition show how to detach the Xtreme45 and allow you to access all major parts groupings. If you wish to merely disassemble a detail role or section you may want to skip particular steps.

Begin disassembly by removing the small Phillips screws on either side of the slide.

Begin disassembly by removing the pocket-size Phillips screws on either side of the slide.
Remove the one.5mm Hex screw only above the correct side Phillips.

Pull the hammer back until it locks into position.

Pull the hammer dorsum until it locks into position.
Take the back piece shown out of the rear of slide.

Loosen the sight screw then the rear sight does not get caught on anything.
Brand sure the Hop Up adjustment screw isn't and so high that it can forestall the slide from coming off.
You may also remove information technology altogether.
Now, you tin can button the slide forwards and off the receiver.

With the slide removed you tin can take the spring and bound guide off.

At present to remove the valve trunk.
First by pushing out the pins shown with a punch tool.
When the pins are role of the way out you can grab them with pliers.
Make sure to remove the pins in the correct direction. If the part of the pin that is sticking is textured then you are doing it correctly. Otherwise start punching the pins the other direction.

With the pins removed the valve body can exist pulled out.
If yous wish to farther disassemble it yous can unscrew the section shown.
This tin exist done by taking a long flat piece of metal and use it similar a flat head spiral driver. The best way to hold the other half is with a vice. Try to avoid using annihilation that volition go out a mark or bend the metal.
One time the cap piece has been removed the following slice can be found inside.

To remove the barrel start by removing the following pins.
Just lift the barrel up and out of the lower receiver.
Be careful not to lose the bound shown.

To remove the hop-upwards and inner barrel from the outer butt kickoff remove the Phillips screw shown.
One time that screw is removed y'all can slide the hop-up and inner butt out.
The hop-up unit is a clam shell design and so by removing the spiral at the top the hop up splits into two and grants you access to the bucking and butt.

You lot can split the hop-upwardly halfs.
Make sure that you do not lose the pocket-size hop-upward nub that fits into a hole in the bucking.
You tin can at present remove the bucking from the barrel.

To remove the trigger grouping first button out the magazine catch with a punch tool.
Then remove the Phillips screw at the back.
Now pull out the safety lever once the screw is removed.

Now the trigger grouping can be removed from the body and your disassembly is consummate.

Conclusion

To reassemble your device, follow these instructions in reverse club.

101 Tech USA

Member since: 08/06/2012

three,955 Reputation

17 Guides authored

0 Comments